X-eng High Performance Off-Road Engineering

Click here for Email
Tel: 01403 888 388 Fax: 08716 617 114
Sharpenhyrst Farm, Plumtree Cross Lane,, Horsham West Sussex, RH13 0NN

Home

Search

View Cart

X-Brake

Suspension

Electrical

X-Anchor

X-Zag

X-Shaft

X-Cap

QuickFist

X-Nav GPS

Product Design

Dealers

Shows

Feedback

Gallery

Sponsored

Terms

Contact

Dealer Login
Click Here

X-Therm Dual Thermostatic Fan Controller

See Thermostatic Switch Data See Fitting Instructions

We have produced these rather nice looking Aluminium, CNC Billet machined in-hose adaptors for standard thermostatic fan controller inserts as used on most cars.

They can be fitted to any vehicle which uses 38mm inside diameter radiator hose.

Some older vehicles use 35mm hose but it will normally stretch over the ends of the adaptor.

The adaptors are available in red or blue anodised finish and are supplied with a dual temperature fan controller insert.

The thermostatic switch insert we supply is designed to switch one fan on at 88 degrees C and off at 83 and the other on at 92 and off at 87 which is about right for most vehicles.

The housing takes standard 22mm thread inserts, available from most motor factors (through Intermotor)

The sensor is capable of switching 17A and will drive the most chunky fans available.

Fans are available in all shapes and sizes. Many are sourced from vehicle breaker yards for only a few pounds. These are easily adapted to fit your vehicle.

Good quality new fans are available from Kenlow and Passet or Spal for most vehicles.

Although all of the above supply thermostatic switches,

some of which are even variable, none of them are capable of switching two fans and they rarely seem to last longer than a few months due to corrosion or water ingress.

Many use a mercury bulb on the end of a copper capilliary tube which needs to be inserted inbetween the top hose and the pipe which comes out of the radiator - it is near impossible to seal this joint and the thin capilliary tube is fragile.

Probably the best testamonial for this kind of switch is that it is used by almost all motor manufacturers to switch electric fans.

We stock the following four kits. It's easier to see what they contain from a picture.

X-Fan Kit (Red)

X-Fan Kit (Blue)

X-Fan + X-Cap (Blue)

X-Fan + X-Cap (Red)

LOOK! We have just taken delivery of genuine Carling Switches (Like the ones used for ARB lockers) with X-Fan labels!

	Carling offer probably the best switches available for off-road use. They are waterproof, use LED lighting and are damn tough! We now stock a range of switches for everything in your
vehicle including Fans and Winches plus a range of mounting panels. See the full range here. The X-Fan switch is of the DPDT On/Off/On type and comes complete with the label shown